3D Printer Filament - ColorFabb 1.75mm WoodFill 750grams

In Stock

Calculate Shipping

Local Pickup - $0.00
Pickup from us in Brendale during business hours, or Arana Hills outside business hours (By Prior arrangement only)

Please note ColorFabb WoodFill is drop-shipped and may not be available for pickup at this time - please check before ordering if you wish to pickup.

If you’re looking for something special in your filament portfolio then consider our woodFill filament. About 70% colorfabb PLA and 30% recycled woodfibres. Your prints will look absolutely amazing and your 3d printer cave will smell like a woodshop! Check out learn.colorfabb.com for a tutorial and slicer profiles on how to print with woodFill.

This listing is for a 1.75mm filament width, 750g roll with 600g of actual filament.


ColorFabb PLA/PHA compound performs well on both heated and non-heated build platforms. For those users printing on a cold build platform we advise applying masking tape to the build area. The rough surface of the tape will provide enough adhesion for the first layer to stick and print almost without any warping.


With the introduction of a local Australian ColorFabb distributor we're happy to annouce we will now be able to stock all standard 'specialty' ColorFabb items directly and for large orders can offer faster turnaround and better discounts.

Printing Recommendations

Advised 3d printing temperature:


Advised 3d print speed:

40 - 100 mm/s

Advised Heated bed temperature: (if you have one, not strictly necessary)


TIP! For stronger prints and better reliability you can increase flow rate with about 0-10%. This will cause the filament to keep going through the hot zone at a steady pace. Also check out our learn.colorfabb.com website for more information and slicer profiles regarding woodFill.

TIP! PLA/PHA has very minimal warping tendencies, however if your printing parts which take up the maximum of you buildspace you might see some warping. If it’s very important that your part is perfectly flat than we suggest to turn down the fan that is cooling your part. This allows the material to slowly get rid of heat without warping. After a few centimeters you can turn on the cooling if the part needs it.



SKU 103
Brand ColorFabb
Shipping Weight 1.0000kg
Shipping Width 0.075m
Shipping Height 0.225m
Shipping Length 0.210m

Be The First To Review This Product!

Help other Orbis Built it Pty Ltd T/A Fabricat3d users shop smarter by writing reviews for products you have purchased.

Write a product review

Others Also Bought

More From This Category